Molecular Structure Explorer
Adamax
Structure of the compound covered in this guide.
Verified structure pending review
Last reviewed: October 2026 · Cleared Peptides research team
Research use only. Adamax: Research Guide is supplied for laboratory research. It is not a drug, food, cosmetic, or dietary supplement. It is not FDA-approved. It is not for human or veterinary administration. This page does not give a dose or a method of administration. A study cited on this page describes that study’s own test article. It does not make this lot an approved medicine. To check a fact, open the PubMed or DOI link, confirm the authors and year, and match the paper’s compound name, CAS number, or sequence to the specification table. The full method is on the research desk page. Identity and purity for a lot are only what that lot’s certificate of analysis reports. An HPLC percentage is not a sterility result and not an endotoxin result unless the certificate prints those tests.
Adamax is supplied as its own synthetic research peptide. A public CAS Registry Number was not found for this designation, so the CAS field is marked not available and the lot COA is the identity record.
Identifiers
| Name | Adamax |
|---|---|
| CAS number | Not available. No public CAS Registry Number was found for this designation in the registry sources reviewed for this guide. Identity, formula, and mass for a lot are on that lot’s COA. |
| PubChem CID | Not available. A matching public compound record was not found. |
| Molecular formula | Not available as one public formula. See the batch COA. |
| Molecular weight | Not available as one public value. See the batch COA. |
| Sequence | Not printed here. The batch COA is the identity record for the lot. |
| Physical form | Lyophilized powder |
| Solubility | Depends on salt form and solvent. Use the lot COA. |
Why the CAS field says not available
A CAS number is assigned to a discrete substance in the CAS Registry. When a catalog designation does not match a public registry entry, this site does not invent a number. Adamax is in that group. The analytical identity of each lot is the Certificate of Analysis.
The Semax guide is a separate page. Semax has its own CAS number, 80714-61-0. That number is not reused for Adamax.
Research material
Other names
Adamax is the catalog designation on this research material. A public CAS Registry Number, PubChem record, formula, and sequence were not found for that designation, so none are invented here. Adamax is not Semax. Semax has its own page and its own CAS number, 80714-61-0. That number is not reused on this page.
How a lot is identified without a public CAS number
When a catalog name has no public compound record, the identity record is the lot Certificate of Analysis. For a peptide lot that means the analytical tests named on that COA, including chromatographic purity and a mass result, rather than a borrowed registry number from a different peptide. Formula, mass, and sequence for a lot stay on that COA until a public registry entry exists.
Analytical testing notes for Adamax
Adamax is identified in this guide as CAS Not available. No public CAS Registry Number was found for this designation in the registry sources reviewed for this guide. Identity, formula, and mass for a lot are on that lot’s COA., formula Not available as one public formula. See the batch COA., listed mass Not available as one public value. See the batch COA.. The sequence recorded here is Not printed here. The batch COA is the identity record for the lot.. An identity test compares a measurement with those values. A mass spectrum is the usual measurement for a peptide. FTIR, when a certificate uses it, is a supporting infrared fingerprint and is less specific for closely related sequences.
For Adamax, routine chemical characterization is reversed-phase HPLC for area-percent purity and mass spectrometry for identity against the formula and mass in the table above. Oxidizable residues (cysteine, methionine, tryptophan) and deamidating residues (asparagine, glutamine), when the sequence contains them, are typical related-impurity questions for the chromatogram and the mass spectrum.
HPLC purity for this material is an area-percent result at the wavelength and gradient the laboratory states, commonly ultraviolet detection near 214 nm on a reversed-phase column. The instrument is a gradient pump, injector, column oven, and UV or diode-array detector. That percentage is not the number of milligrams in the vial. Water, acetate, trifluoroacetate, and other UV-silent material can dominate the gross weight while the purity figure stays high. Net peptide content, from an assay or amino-acid analysis, is the separate result to read when the certificate reports it.
A sterility test and an endotoxin test are not included in a chemical purity result. The compendial sterility test is a culture method (USP <71>): membrane filtration or direct inoculation into fluid thioglycollate medium and soybean-casein digest medium, incubated for 14 days. A PCR sterility screen uses a thermal cycler to detect microbial DNA and is a different method. The endotoxin test (USP <85> LAL, or USP <86> recombinant Factor C) reports endotoxin units with an incubating reader or a cartridge reader. Use a result only when that method is printed on the lot certificate. One published example in this catalog states that the report does not cover microbial contamination or endotoxins. The full description of equipment, standards, and how US laboratory accreditation works is in peptide analytical testing. Lot records are on the COA page.
Frequently Asked Questions
Why is the CAS field marked not available?
No public CAS Registry Number was found for the designation Adamax. This site does not fill the gap with a number from Semax or from any other peptide.
Is Adamax the same compound as Semax?
No. Semax is a separate guide and a separate registry entry, CAS 80714-61-0.
Is Adamax for human use?
No. It is supplied for laboratory research use only and is not for human or veterinary use.
Selected References
Peer-reviewed literature listed as scientific background for laboratory researchers. Citation does not imply endorsement by the authors, and it is not a statement of benefit or use.
- No peer-reviewed paper is cited here because a public paper that assigns a CAS Registry Number, formula, and sequence to this catalog designation was not identified in the review for this page. The lot COA remains the identity source.
Research Use Only Notice
This guide is provided for educational and laboratory reference purposes. It summarizes published structural and biochemical literature. It does not describe, recommend, or imply any use in humans or animals. Products sold by Cleared Peptides are for laboratory research use only. They are not drugs, foods, cosmetics, or dietary supplements, are not FDA-approved, and are not intended to diagnose, treat, cure, mitigate, or prevent any disease. No dosing, administration, or use instructions are provided.
